GLP impression X5 IP Bar 1000 User Manual page 28

www.glp.de
See Figure 3. The top line of the default information screen consists of, from left to right:
● Main CPU firmware version
● DMX Mode
The center of the screen shows the following information:
● Signal source.
● Fixture's current DMX address in large characters. If the fixture's self-diagnosis
system detects an error, the fixture will flash an error message alternately with the
DMX address. This lets you see the DMX address and error message at a distance
from the fixture.
● If the fixture detects a valid, active network at one of the fixture's etherCON ports,
the default screen will show a network icon to the left or right of the DMX address:
Icon on left = data at Port A (on left of fixture when facing control panel)
-
Icon on right = data at Port B (on right of fixture when facing control panel)
-
The fixture displays network speed below the network icon.
If the fixture does not detect a network at one of the ports, it displays NO LINK
instead of the network icon for that port.
● Below the current DMX address, the fixture displays in smaller characters the DMX
channels that the fixture is currently using.
In the example shown in Figure 3:
● The fixture is running CPU software version 1.1.3
● The fixture is set to DMX Mode 1
● The fixture is set to receive data via DMX
● The fixture's DMX start address is 001
● The fixture is using DMX channels 1 to 24.
28 impression
X5 IP Bar 1000 User Manual
X5 IP Bar 1000