Part Ii - Invoke Upload Mode Via The Front Panel; Part Iii - Invoke Upload Mode Via The Terminal Program - evertz HD9626DSK Instruction Manual

Start the terminal program.
Configure the port settings of the terminal program as follows:
Baud 57600
Parity no
Data bits 8
Stop bits 2
Flow None
Control
Power-up the Evertz frame.
Part II – Invoke upload mode via the front panel
Note: If you cannot invoke the upload mode via the front panel outlined in Part II then follow the steps
in Part III.
Press the SETUP button once.
Press the down arrow until the main display reads General.
Press the SELECT button once.
Press the down arrow until the main display reads Update code.
Press the SELECT button once.
The main display should now show the message Select = Upgrade.
Press the SELECT button to confirm the Upgrade operation, press Setup to cancel.
Skip to step 14.
Part III – Invoke upload mode via the terminal program
A banner with the boot code version information should appear in the terminal window.
For example:
EVERTZ 7700FC BOOT MONITOR.
MON8240 1.1 BUILD 9.
COPYRIGHT 2000 EVERTZ MICROSYSTEMS LTD. ALL RIGHTS RESERVED.
UPLOAD MAIN PROGRAM
15. The following is a list of possible reasons for failed communications:
Defective RS-232 "straight-thru" serial extension cable.
Firmware Update Procedure Revision 1.0
HD9626DSK Instruction Manual
Page 5-2