Hd9625Dsk Hardware; Rear Panel Overview - evertz HD9626DSK Instruction Manual

2 HD9625DSK Hardware

2.1 REAR PANEL OVERVIEW

Note: New pict here!
HD9626DSK
•
SERIAL CONTROL is an RS-422 OR RS-232 serial interface used for controlling the unit through
automation. Operational mode (422 or 232) can be set from the front panel. Pin out configurations
are supplied later in the chapter. The pin out configuration will change depending on the operational
mode selected. Default mode from the factory is RS-422.
•
REMOTE PANEL is an RS-422 serial interface used for connecting the RCP (remote control panel)
or DCP (desktop control panel). This DB9 connector will only be installed if you purchased either
of these options. Please refer to the DCP/RCP section of this manual for pin out information for this
port.
•
UPGRADE RS232 is an RS-232 serial interface used for connecting the unit to a PC for firmware
updates. Please use the straight though 9 pin serial cable supplied with your unit. Please refer to the
firmware upgrade section of this manual for pin out information for this port, and instructions on
performing a firmware upgrade.
•
COM D is a serial interface (RS232/422) which can be used for automation
•
GPIO Connector is used to provide Preset selection commands to the DSK. Please refer to the GPIO
section of the manual for pin out and connection information. Preset information is available in the
On Screen Section of the manual.
•
ETHERNET Connector is used for automation control and firmware upgrade connections. Initial
product release does not support this option, however the firmware will be upgraded shortly to
provide user access to these functions, and as such the hardware is provided with all units.
•
HD OUTPUT PREVIEW, output BNC connector for serial component SMPTE 292M video. This is
the preview output connector that should be connected to an appropriate HD monitor. This output is
not ByPass protected.
•
HD OUTPUT PROGRAM, output BNC connector for serial component SMPTE 292M video. This
is the program output connector that should be connected to an appropriate HD downstream device.
This output is ByPass protected and will pass video in the event of a power loss to the unit. Please
connect your downstream devices to the PROGRAM output connector.
•
HD INPUT A and B, These BNC connectors allows you to supply 2 video feeds to the DSK. Thes
connectors supplies the A and B source video for side by side compares. The A input is the ByPass
protected input for the unit. In the event of power loss, the video source from this BNC will
On Screen Menu Revision 1.0
HD9626DSK Instruction Manual
Page 2-1