Transition - evertz HD9626DSK Instruction Manual

HD9626DSK Instruction Manual

2.8 TRANSITION

Transition Type: Select the type on transition you would like applied when the Transition button is
pressed. Options are Cut, Fade, Fade-Cut, Fade-Fade, Cut-Fade, Diamond Out, Diamond In, Circle
Out, Circle In, Box Out, Box In, TB Split, LR Split, TB Curtain, LR Curtain, TR Box, TL Box, BR Box,
BL Box, Wipe 315, Wipe 270, Wipe 225, Wipe 180, Wipe 135, Wipe 90, Wipe 45 or Wipe 0. (item
orders may vary). Transition effects only appear of the program output. Transitions on the Preview
Output are always Cut type performed at the end of the transition to program. The numbers following
the Wipe reference the angle of the wipe. This also indicates the direction of the wipe. For example a
wipe of 45 will start a 45 degree wipe that will progress from the top left of the screen to the bottom
right of the screen. See the diagram below for example. Arrows indicate direction of wipe.
Transition Rate: Set the time for the transition to take affect. The setting is referenced in frames.
Quick access provide from front panel Rate button.
Swap Mode: Toggle Swap/No Swap setting for whether the program and preview channels are
swapped after a transition command is issued.
Pause: When set to On, the transition may be paused by pressing the Transition button while the
transition is being performed. To continue the transition press the Transition button again. When set to
Off, the transition cannot be paused.
On Screen Menu Revision 1.0 Page 2-10