First Time Setup; Rear Panel Hook Up - evertz HD9626DSK Instruction Manual

If you require Technical support from the factory you can contact our technical support department by
one of the following methods.
Email
Fax
Please include a detailed description of the problem you are having, the model number of your unit,
serial number and Build Number. The Build Number can be obtained from the "On Screen Menu"
system. Press "Setup" then select "General" then select " Update Code".
You can also consult the FTP site (http://www.evertz.com/ftp.html) on our web page for the latest
patches, upgrades and lists of Frequently Asked Questions.
The DCP instructions are included in Chapter Error! Reference source not found. of this manual.
The DCP is optional and only ships with orders purchased with this option. DCP stands for Desktop
Control Panel. Please refer to that document for button descriptions as it replaces section 2.4 of this
manual. The DCP option is not field upgrade-able, if you wish to operate the unit with the DCP option,
and you didn't specify this at the time you placed your order, you will be required to send your unit
back to the factory for a retrofit.

1.3 FIRST TIME SETUP

1.3.1 Rear Panel Hook Up

Note: New pict here!
HD9626DSK
Connect the incoming video signals to the A and B, input BNC connectors for HD serial digital SMPTE
292M video. A video signal should be supplied prior to applying power to the box.
Connect the main HD serial digital video output, HD Output PROGRAM to the next device in the video
path. There are 2 BNC connectors to output program video compatible with SMPTE 292M video. One
output is wired as a bypass output and will provide video pass through in the event of power loss to the
unit.
The BYPASS output is the only output BNC that is connected to the bypass relay. This output will be
connected to the program input in the event of a power failure or a bypass command as issued from
the front panel button press. This is labeled as BYPASS on the rear panel.
The UPGRADE RS232 is an RS-232 serial interface used for updating firmware in the HD9626DSK
model. Connect this using a standard 9pin straight through serial cable, to the PC. Automation control
will be available on the DB9 connector labeled SERIAL CONTROL providing automatic control of the
unit.
The HD9626DSK has a universal power supply that operates on either 115 Volt / 60 Hz or 230 Volt /
50 Hz AC. The power supply auto switches between the voltages. A second redundant power supply
purchase option operates in conjunction with the original power supply.
OVERVIEW
mailto:service@evertz.com
+1 (905) 335-7571
Revision 1.0
HD9626DSK Instruction Manual
Phone +1 (905) 335-7570
Page 1-2