Chap.09 Fault Diagnosis And Troubleshooting; Problems - Jolly Mec AERJOLLY 80 EVO 15 Instructions For Installation, Use And Maintenance Manual
Hide thumbs
Also See for AERJOLLY 80 EVO 15:
Table of Contents
Advertisement
CHAP.09 FAULT DIAGNOSIS AND TROUBLESHOOTING
09.1
PROBLEMS
WARNING
In accordance with the laws in force on safety for electrical appliances, a specialised Technical Service Center or
qualified personnel must obligatorily be contacted for all installation, maintenance or interventions that require access to
electrical parts.
PROBLEM
The control unit does not
switch on
Excessive condensation
forms inside the fireplace
The fan doesn't work
Smoke escapes when the
door is opened, the wood
burn poorly, or the glass
gets dirty
WARNING
Do not use the device if the draft is not regular, and if combustion is not great.
42
MAIN CHECKS TO BE PERFORMED
•
Check for possible power supply or mains problems.
•
The control unit is faulty.
•
Check the quality of the fuel used.
•
Check the draught.
•
Insufficient air intake size.
•
Check for possible power supply or mains problems.
•
The temperature probe is faulty or disconnected.
•
The fan is faulty or disconnected.
•
Make sure that the fun functions in "manual" mode.
•
If the fireplace is installed in a room in communication with a stairwell, with major depression that exists in the
local, close off the stairwell by installing a door.
•
There are other appliances that use room air, creating low pressure. Use the fireplace when the other
appliances are off (excluded of the type "C" according to UNI 10683).
•
Load the wood when there is no flame.
•
Place the baffle correctly (see
•
The outside air inlets and/or the flue are partially or completely obstructed. Clean or remove the obstructions.
•
Air inlet and/or canalisations not correctly done.
•
Check the uptake value that must be between 10 and 14 Pa (see chap. 07.1).
•
Insufficient flue draught: there are horizontal sections or 90° bends, or the chimney cap is located under the
ridge of the roof (installation errors). Replace the horizontal sections with sections at 45°; raise the chimney
cap, or fit an antiwind cap.
•
Check that the flue conforms to the indications given in
SYSTEM
, clean the flue and smoke baffle, open the damper, open the door slowly
CHAP. 08.5 - ASSEMBLY SEQUENCE
CHAP.07.1 - FLUE OR FUME EXHAUST
).
Advertisement
Table of Contents
