Chap.08 Use And Maintenance For The User; Appliance Start And Use - Jolly Mec AERJOLLY 80 EVO 15 Instructions For Installation, Use And Maintenance Manual

CHAP.08 USE AND MAINTENANCE FOR THE USER

08.1

APPLIANCE START AND USE

Fig. 1
Fig. 2
The appliance's combustion is intermittent and it is obtained by positioning a new load of wood on the fireplace at the end of combustion
of the previous charge.
To achieve the declared nominal heat output, adjust the unit as follows:
Model
AERJOLLY 80 EVO 15
AERJOLLY 80 EVO 15 CT
Max length 30-35 cm and width approx. 8-10 cm per side (use of pieces of chopped wood is recommended)
Fig. 3
Fig. 3a
Wood quantity
2 identical logs for a total of 3,87 kg
(Fig. 3);
3 identical logs for a total of 3,23 kg
(Fig. 3);
Before switching on the device for the first time it is necessary to
remove from inside all documentation and accessories that come
together in the supply and read the instructions for use, especially
the parts about the recommended fuels and other most relevant
issues.
The commissioning service has to be done by a specialised
Technical Service Center.
Before starting the fireplace, check that the control unit is switched
on and functioning then turn the comburent air regulating lever to
position MAX (Fig. 1).
Small pieces of wood (maximum LxHxW 35x4x4 cm) must be used to
light the fire, stacking them on the fireplace grate (as seen in Fig. 2).
Standard fire-lighters can be used to make the starting phase easier
(never use ethyl alcohol or other inflammable liquids). The door can
be left slightly open during the fire starting phase.
Only when the first charge of wood is ended will be possible to
charge again wood, as indicated at the end of the chapter 08.2, the
wood need to be placed at the center of the fireplace in horizontal
sense. To maximise fireplace efficiency and avoid the leakage of
combustion fumes, the fireplace must be loaded when the flame goes
out. Before placing the wood on the fire base, it is recommended to
break and evenly distribute the cinders using a cinder tray.
Comburent air record
(Fig. 4)
Position with visible X letter
Position in the middle of the adjustment
(Fig. 5) ;
slot
Fig. 4
Fig. 5
Recharging time
50 minutes
49 minutes
37