Advertisement
Available languages
Available languages
O0_Ve_'ti_g
tO
LP
Gas
(or Converting
Back to Natural
Gas from
LP)
This range leaves the factory set for use with natural gas.
If you convert to LP gas, keep these instructions
and ori-
fices in case you want to convert back to natural gas
Prepare the Range for Conversion
CAUTION--Before
converting the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical power to the range,
If range has not yet been connected
to gas supply, or
if flexible
connection
was made, range may be pulled
out from the wall to make conversion
easier
Tools Required:
• %10 Torxdriver
(for sealed burners)
o 1/2" and 3/4" open-end
wrench
o Flat blade screwdriver
(small)
o Nut drivers
or wrenches:
7mm, 5/I6"
or a small
adjustable
(depending
on the size of the spuds)
$1.e
t
Convert The Pressure ReguRator
WARNING:
Do not remove
the pressure
regu-
lator from
the range.
1. For models
equipped
with sealed burners,
remove
the storage drawer, broiler drawer or kick panel and
locate the pressure
regulator
at rear of the range
On some models, you may have to remove an access
cover also
For models
equipped
with dual burners,
remove
the
cooktop
and locate the pressure
regulator
at right rear
of range
2. Follow the directions
in A or B, that match your reg-
ulator type
A Dual Burner Models
(models
with lift-up cooktops)
If it is regulator
A:
1. Use a coin to remove
the cap from the pressure
regulator
2. Turn
the
cap
over
and
hook
it into the
slots°
The type of gas to be used should
now be visible
on the top of the cap
43
Sealed Burner Models
(models
without lift-up cooktops)
If it is regulator
B:
1. Unscrew
the plastic-protected
hex-nut
cap from the
regulator
2, Carefully
pry
the
protective
plastic
cap
off
the threaded
metal
cap.
Gently
pull
the plastic
washer
off the threads
on the other
side
of the
metal cap
3, Push the plastic cap onto the end of the metal cap
displaying
the type of gas you are converting
to
Press the attached
plastic washer
onto the threads
on the other side of the metal cap.
4. Screw the hex-nut
cap back into the regulator
Do
not overtighten_
DUAL BURNERS
NAT
Cap
k._...!_
into Range _X..____
-_-_
_
PUSH DOWN
..!
-
TO OPEN
_
LP
Cap
SEALED BURNERS
Gas
Lever shown ctosed
Flow into
PUSH DOWN
TO OPEN
Do not remove
this protective cap
except for conversion
Cap Assembly
(continued next page)
Advertisement
