Dell 0G8DW Installation And Service Manual page 14

Table 4. Left control panel
Item Indicator or button
1 Status LED indicators
2 System health and system
ID indicator
3 iDRAC Quick Sync 2
wireless indicator (optional)
NOTE:
Sync 2 wireless
indicator is available
only on certain
configurations.
Status LED indicators
NOTE: The indicators display solid amber if any error occurs.
Table 5. Status LED indicators and descriptions
Icon Description Condition
Drive The indicator turns solid amber if
indicator there is a drive error.
Temperature The indicator turns solid amber if
indicator the system experiences a thermal
error (for example, the ambient
temperature is out of range or
there is a fan failure).
Electrical The indicator turns solid amber if
indicator the system experiences an
electrical error (for example,
voltage out of range, or a failed
power supply unit (PSU) or voltage
regulator).
Memory The indicator turns solid amber if a
indicator memory error occurs.
14 Dell EMC PowerEdge R640 system overview
Icon
N/A
iDRAC Quick
Description
Indicate the status of the system. For more information, see the
Status LED indicators
Indicates the system health. For more information, see the
health and system ID indicator codes
Indicates if the iDRAC Quick Sync 2 wireless option is activated. The
Quick Sync 2 feature allows management of the system using mobile
devices. This feature aggregates hardware/firmware inventory and
various system level diagnostic/error information that can be used in
troubleshooting the system. You can access system inventory, Dell
EMC Lifecycle Controller logs or system logs, system health status,
and also configure iDRAC, BIOS, and networking parameters. You can
also launch the virtual Keyboard, Video, and Mouse (KVM) viewer
and virtual Kernel based Virtual Machine (KVM), on a supported
mobile device.Dell.com/poweredgemanuals
Corrective action
• Check the System Event Log to determine if the drive has an error.
• Run the appropriate Online Diagnostics test. Restart the system and
run embedded diagnostics (ePSA).
• If the drives are configured in a RAID array, restart the system, and
enter the host adapter configuration utility program.
Ensure that none of the following conditions exist:
• A cooling fan has been removed or has failed.
• System cover, air shroud, memory module blank, or back filler bracket is
removed.
• Ambient temperature is too high.
• External airflow is obstructed.
If the problem persists, see
Check the System Event Log or system messages for the specific issue. If
it is due to a problem with the PSU, check the LED on the PSU. Reseat the
PSU.
If the problem persists, see
Check the System Event Log or system messages for the location of the
failed memory. Reseat the memory module.
If the problem persists, see
section.
section.
Getting help.
Getting help.
Getting help.
System