Updating Firmware And Software; Updating Firmware - SMART Board SPNL-6275-V3 Installation And Maintenance Manual

CHAPTER 6
MAINTAINING THE DISPLAY
4. Remove all accessible cables and connectors.
5. Remove the iQ appliance from the accessory slot.
6. Lift the display from its mounting location.
WARNING
Do not place the display on a sloping or unstable cart, stand or table. The display could fall,
resulting in injury and severe product damage.
CAUTION
Do not leave the display face up, face down or upside down for an extended period. This
could cause permanent damage to the screen.
7. Remove the mounting brackets.
To transport the display
See Moving the display to the installation site on page 17.

Updating firmware and software

Updating firmware

The display uses firmware on its processor. Updates to SMART software could include a firmware
update in the form of a downloaded firmware executable file. When the display detects this
executable file, you're prompted to run the file to update the firmware.
CAUTION
Only a system administrator should update display firmware.
l
Only one display can be connected to the computer during the firmware update.
l
Do not disconnect the display from your computer during the firmware update.
l
Do not touch the display screen or input button during the firmware update.
l
Do not turn off your computer or the display during the firmware update.
l
To update firmware
See SMART Board 6000 series
46 smarttech.com/kb/171167
firmware.