Preventing Condensation; Replacing The Pens; Turning The Display Off And Back On - SMART Board SPNL-6275-V3 Installation And Maintenance Manual

CHAPTER 6
MAINTAINING THE DISPLAY
CAUTION
Avoid setting up or using the display in an area with excessive levels of dust, humidity or smoke.

Preventing condensation

If the display has been moved from a colder environment to a warmer environment (for example,
from storage to the installation site), let the display sit for a few hours so that it can acclimate to the
new temperature. Failing to do so can cause humidity to build up in the space between the front
glass and the LCD.
If condensation appears under the screen after you turn on the display, select an active video
source and leave the display on for 48 hours. If the condensation doesn't dissipate, contact SMART
Support if the display is still under warranty.
If there is enough moisture between the layers to cause the moisture to drip and run, remove
power immediately and contact SMART Support if the display is still under warranty.

Replacing the pens

To prevent damage to the display's anti-glare coating, replace a pen if its nib or eraser pad
become worn. You can purchase replacement pens from the Store for SMART Parts
(see smarttech.com/Support/PartsStore).

Turning the display off and back on

In some situations, you need to turn off the display for a period of time. You can turn it back on
after.
To turn the display off
1. Press the Standby button
2. Flick the switch beside the AC power inlet to the OFF (O) position.
NOTE
Wait at least 30 seconds before turning the display back on.
44 smarttech.com/kb/171167
on the front control panel twice.