Installation instructions
3.8 Documentation
4. Start the machine:
•
Check the direction of rotation of the pumps
NB! If the direction of rotation is wrong, the phase must be inverted on the
incoming feed.
•
Check that the overload switch on the feed cradle is functioning.
5. Lock the impulse arm and the photocell in the activated position:
•
Run the machine continuously for 10 minutes. Check and adjust the tem-
perature and water flow
•
Final rinse (around 7 litres/minute)
•
Reset the impulse arm and the photocell to the initial position.
6. Run a number of washes complete with dishware and check:
•
The basket is in the correct position after the photocell
•
There are no water leaks
•
The door switch works
•
The limit switch is working
•
Steam discharge from the machine
•
The water temperatures are maintained
•
The dishware is clean
N.B.: If the machine is equipped with detergent dosing, this function is
roughly set at the factory; contact your chemical supplier for a more precise
setting.
•
The dishware is dry
N.B.: If the machine is equipped with drying agent dosing, this function is
roughly set at the factory; contact your chemical supplier for a more precise
setting.
7. Final check: Empty the machine, turn the machine off using the ON/OFF
button and then turn off the power at the power switch:
•
Re-tighten all the connections on the circuit breakers and contactors
•
Check that all the mini-switches and the motor cut-off switch are in the on
position.
•
Display the quick guides supplied with the machine
8. Train and inform personnel concerning:
•
Washing
•
Care (daily, weekly and other frequencies)
•
Recommendation for annual service
For correct use and servicing, it is essential that the documentation accompany-
ing the machine is made available to personnel who will be using the machine.
The installation and user manual, which describes handling and care among oth-
er things, should be stored near the machine.
WD-11
touch
22
Rev. 00 (202310)