Table of Contents
Advertisement
Operating instructions
PROBLEM
The machine does not fill with
water.
The machine fills slowly.
The machine does not stop fill-
ing.
The machine does not start
washing.
Noise from the washing pump.
The machine is not cleaning
properly.
The dishware has tipped over in
the baskets.
Dishware does not dry.
WD-11
touch
CAUSE
The incoming water stopcock is
closed.
The door/hood is open.
The final rinse pipe nozzles are
blocked.
The final rinse pipe nozzles are
blocked.
Level pipe or drain seal not in place.
The level pipe or one of drain seals'
rubber sleeves are not sealing
against the bottom plate.
The door/hood is open.
Dishware is blocking the magnet in
the door.
Outward feed conveyor limit switch
has been activated.
Low water level. Foam in the tank.
The rinse and wash nozzles are
clogged with dirt.
There is too little detergent.
The water in the tank is too dirty.
Foam forming in the tank.
The contact time is too short.
Dirt has dried on the dishware to be
washed.
The dishware is incorrectly posi-
tioned in the baskets.
Detergent and drying agent of anoth-
er make than usual are used.
The dishware is incorrectly posi-
tioned in the baskets.
Light dishware need washing.
The rinse nozzles are blocked.
Too little rinsing agent.
The washed items have been left in
the machine.
45
Rev. 00 (202310)
ACTION
Open the tap.
Close the door/hood.
Clean the wash nozzles.
Clean the wash nozzles.
Fit the level pipe or drain seal.
Check that the level pipe and drain
seals are closed. Replace the rubber
sleeves, if they are damaged.
Close the door/hood.
Remove the dishware in question.
Remove the basket from the limit
switch.
Check the level. Change the water.
Check and clean the nozzles.
Check the amount of detergent. The
hose must be submerged in liquid
and the filter in the hose must be
clean.
Change the water.
Check that the washing temperature
is not too low and that the correct de-
tergent is being used.
Select a longer contact time.
Soak the dishware before washing.
Use the correct type of washing bas-
ket and accessories to ensure that
the dishware is correctly positioned.
Use the same make and type as be-
fore.
Put the dishware in the correct posi-
tion.
Use a net grid to hold the items.
Check and clean the nozzles.
Check the amount of rinsing agent.
The hose must be submerged in liq-
uid and the filter in the hose must be
clean.
Remove the washed items once the
programme has ended.
Advertisement
Table of Contents
