Table of Contents
Advertisement
Installation instructions
3.5.4 Drain/waste pipe
The waste water system connected to (3 or 8) should consist of a 50mm metal
pipe that will withstand mechanical impacts. The waste pipe must run to a floor
drain, where its opening must be above the water level.
The drain can be fitted to the right or left. Remove the perforated section of the
end plate and pull the pipe through the hole. Connect the drain and run to the floor
drain where it should flow freely above the water level.
Ensure that the drain connection is kept in place by using e.g. cable ties in the
designated areas.
3.5.5 Detergent and drying agent
•
•
•
•
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
The process of setting the detergent and drying agent dispenser is described in
the ADJUSTMENT INSTRUCTIONS.
For information about wiring diagram, see the machine's wiring diagram.
WD-11
touch
Check what your machine is equipped with, which depends on the model,
machine type and country.
Use the same make and type of detergent and drying agent.
With machines connected to cold water, the water pipe temperature may
be too low for use of powder or paste type detergents.
If liquid detergent is used together with Wexiödisk's detergent pump, the
detergent must be placed under the machine's tank level.
15
Rev. 00 (202310)
Advertisement
Table of Contents
