Table of Contents
Advertisement
7. Install the replacement lower power distributor board into the same position
on the fl oor of the motherboard node, aligning the mounting holes of the
board with those in the node.
Figure 6-13: Installing the Lower Power Distributor Board
8. Secure the lower power distributor board with the two screws previously set
aside. Do not exceed eight pounds of torque when tightening the screws.
9. Put the support bracket back into place in the node and secure it with the
screw previously set aside.
10. Secure the upper power distributor board to the support bracket using the
four screws previously set aside. Do not exceed eight pounds of torque when
tightening the screws.
Figure 6-14: Installing the Upper Power Distributor Board
11. Replace the air shroud as described on page 5-20 and return the node to its
bay in the chassis.
12. Reattach the power cord to the back of the power supply and power up the
node.
Chapter 6: Advanced Chassis Setup
1
7
1
10
6-13
Advertisement
Table of Contents
