Table of Contents
Advertisement
Fan Headers
This serverboard has eight 4-pin
(Fan1~Fan8), and one 3-pin (Rear_Fan1)
system/CPU/cooling fan headers on the
serverboard. The 4-pin fan headers are
backward compatible with traditional
3-pin fans. However, fan speed control
is only available on 4-pin fans via IPMI
fi rmware management. See the table on
the right for pin defi nitions.
IPMB
A System Management Bus header for
IPMI 2.0 is located at JIPMB1. Connect
the appropriate cable here to use the
2
IPMB I
C connection on your system.
SATA DOM Power Connector
A power connector for SATA DOM
(Disk_On_Module) devices is located
at JSD1. Connect an appropriate cable
here to provide power support for your
SATA DOM devices.
T-SGPIO 1/2 & 6-SGPIO 1/2 Headers
Four SGPIO (Serial-Link General
P u r p o s e I n p u t / O u t p u t ) h e a d e r s
(T-SGPIO 1/2 & 6-SGPIO 1/2) are
located on the motherboard. These
headers support onboard Serial_Link
interface connections.
Note: T-SGPIO 1/2 support onboard
SATA connections. 6-SGPIO 1/2 support
SAS interface on the X9DRFF-7G+ and
X9DRFF-7TG+ serverboards only.
Chapter 5: Advanced Motherboard Setup
(Fan 1~8, Fan 9)
Pin Defi nitions
Pin# Defi nition
1
Ground
2
+12V
3
Tachometer
4
PWR Modulation
(Available for 4-pin fans only)
Pin Defi nitions
Pin#
1
2
3
4
DOM PWR (JSD1)
Pin Defi nitions
Pin# Defi nition
1
2
3
Pin Defi nitions
Pin#
Defi nition
1
NC
3
Ground
5
Load
7
Clock
NC indicates no connection.
5-21
Fan Header
IPMB Header
Defi nition
Data
Ground
Clock
No Connection
+5V
Ground
Ground
T-SGPIO 1/2
S-SGPIO 1/2
Pin
Defi nition
2
NC
4
Data
6
Ground
8
NC
Advertisement
Table of Contents
