Supermicro Super FatTwin F627G3-FT+ User Manual page 93

Installing a Hard Drive into the Drive Carrier
1. Place the hard drive carrier on a fl at surface.
2. Insert the hard drive into the carrier with the printed circuit board side facing
downward and so that the mounting holes in the drive align with those in the
drive carrier.
3. Secure the hard drive to the carrier with the screws included with the hard
drive.
4. Use the open handle of the drive carrier to insert the drive carrier into the
open drive bay.
5. Secure the drive carrier into the drive bay by closing the drive carrier handle.
Figure 5-5: Installing a Hard Drive into the Drive Carrier
1
4
Drive Carrier
Caution: Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended HDDs,
visit the Supermicro Web site at
storage/SAS-CompList.pdf
SAS or SATA
Hard Drive
http://www.supermicro.com/products/nfo/fi les/
6-7
Chapter 6: Advanced Chassis Setup
1
4