Table of Contents
Advertisement
A W A R N I N G - - - - - - - - - - - - - - - - - - - - - - - - - - - - - .
To reduce the risk of electric shock, fire, explosion, serious injury
or
death:
• Disconnect electric power to the washer before servicing.
•
Never start the washer with any guards/panels removed .
•
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
woo3
48.
OUTER
TUB
DOES NOT EMPTY
POSSIBLE CAUSE
TO CORRECT
Kinked drain hose.
Straighten hose.
Drain hose out of clamp in back of cabinet.
Remove washer front panel and install drain hose
into clamp.
Inoperative water pump.
Replace pump.
Obstruction in outer tub outlet
hose.
Remove obstruction.
49.
EXCESSIVE VIBRATION
•I
:
TO CORRECT
Unbalanced load in tub.
Stop
washer,
redistribute
load,
then restart washer.
Broken,
or disconnected centering spring(s)
.
Connect or replace centering
spring(s).
Washer is not properly leveled
.
Adjust leveling legs.
Washer is installed on weak, "spongy"
,
carpeted
Relocate washer, or support floor to eliminate weak or
or built-up floor.
"spongy" condition.
•
Incorrect or loose cabinet screws
.
Replace with correct screws or tighten.
Base damaged (washer was dropped).
Replace base assembly.
Balance ring not positioned properly on
Refer to paragraph
27.
transmission assembly.
Lubricant on Pivot Dome and/or Snubber Pad
Remove lubricant.
and isolator assembly.
50.
WATER LEAKING FROM OUTER TUB
POSSIBLE CAUSE
• •
••
Leaking water seal in outer tub.
Replace hub and seal kit assembly, paragraph 22.
Hole in outer
tub.
Replace
outer tub.
Pressure hose or accumulator
leaking
.
Replace pressure hose and/or accumulator.
Outer tub cover gasket leaking.
Replace
gasket.
Obstruction in drain causing
water
to come over
Remove
obstruction.
top of
outer
drain tub cover.
Tub-to-pump
hose
leaking
at clamp.
Tighten clamp .
•
36793
67
Advertisement
Table of Contents
