Raytheon Speed Queen AWM190 Service Manual page 61

•
•
•
32.
PRESSURE SWITCH (Refer to Figure 59)
NOTE: DO NOT ADJUST PRESSURE SWITCH IF
WASHER IS WITHIN THE WARRANTY PERIOD.
Pressure switch is set at the factory for proper
water fill levels. However, if there is a problem of
overfilling or undertilling, pressure switch can be
adjusted.
Maximum water fill level can be increased by
turning adjusting screw CLOCKWISE, and
decreased by turning screw
COUNTERCLOCKWISE.
One quarter turn of the adjusting screw
represents approximately one inch (2.54 cm)
increase or decrease of water level in washtub.
IMPORTANT: DO NOT turn adjusting screw more
than 3/4 of a turn in either direction as the switch
may be damaged and flooding could result.
33. BELT (Agitate and Spin)
No belt adjustment is required.
36793
59
Fixed Pressure Switch
ADJUSTING
SCREW
Rotary Pressure Switch
ADJUSTING
SCREW
Side Pressure Switch
ADJUSTING
SCREW
Figure 59
W275SE1A