Table of Contents
Advertisement
•
•
•
A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~-.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
h. Disconnect hose from bottom of outer
tub.
i.
Remove pressure hose from pressure
bulb.
Then remove
tape
holding
pressure
hose to outer
tub,
Figure
52.
j.
Grasp outer tub and lift complete tub module
assembly (with transmission, balance ring
,
and pivot dome attached) straight up and out
of washer cabinet.
k. Turn complete tub module upside-down and
set on protective padding
.
I.
Remove screws holding three support legs
to pivot dome and remove
dome,
Figure
49.
m.
Remove
screw,
washer and helix holding
drive pulley to input shaft of
transmission
assembly,
Figure 50.
n.
Lift drive pulley up and out from between tub
support
legs.
NOTE: When reinstalling pulley, place a small
amount of No. 03200 Lubricant on top side of the
drive pulley that will be contacting large flat
washers. Lubricate helix ramps and bore with a
small amount of No. 03200
Lubricant.
See Figure 51.
DRIVE
PULLEY
WASHER
IMPORTANT: DO NOT OVER LUBRICATE!
Excess lubricant can be thrown into pivot dome
area during normal washer operation. Any
lubricant
on pivot dome or
isolator
will
cause
premature tripping of
the
out-of-balance switch.
This condition will persist until
lubricant
is
removed.
CAP SCREW
HELIX
W182SE3A
Figure 50
36793
43
Advertisement
Table of Contents
