Table of Contents
Advertisement
•
•
•
A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~---.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
BALANCE
RING
APPLY
NO.
27604P
ANTI-SEIZE COMPOUND
TO THIS AREA OF
BOTH UPPER AND
LOWER TRANSMISSION
TUBES
MARKED SIDE
OF BALANCE
RING
RACK AREA OF
TRANSMISSION
W185SE3A
Figure 53
w.
Remove four screws and lockwashers holding
transmission assembly
to
balance
ring,
Figure
53,
then lift transmission assembly
straight up and out of balance ring and upper
bearing
.
IMPORTANT:
When replacing or reinstalling
transmission
assembly,
it is important that
No. 27604 Anti-Seize Compound be applied to
area of the transmission tubes where they will be
contacting upper and lower bearings, Figure
53.
36793
51
When reinstalling transmission
assembly,
note, if
there is a mark located on outer edge of balance
ring this mark (if
present)
indicates light side of
ring.
This light side must be installed at a 9
o'clock position with center
of rack
at 12 o'clock
when viewed from top of
transmission,
Figure
53.
Carefully lower transm ission through balance ring
and upper bearing. DO NOT DROP OR LOWER
TRANSMISSION ASSEMBLY INTO POSITION TOO
HARD,
this can cause bearing to move within
bearing housing which will cause
vibration, noise,
wear or no spin .
Advertisement
Table of Contents
