Raytheon Speed Queen AWM190 Service Manual page 65

•
•
•
A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~--,
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed .
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
woo3
40. MOTOR DOES NOT RUN
POSSIBLE CAUSE
• •
••
Electrical power off, fuse blown, or power cord not Check laundry roo m for blown or loose fuse(s) or
plugged in. open circuit breakers. (Washer itself does not have an
electrical fuse).
Loading door not closed or inoperative switch. Close door or test switch and replace if inoperative.
Timer improperly set. Reset timer, or try another cycle.
Inoperative timer. Test timer and replace if inoperative.
Motor starting functions inoperative. No start; Refer to SECTION V to check start switch and start
or motor hums only. windings.
Motor is dead, won't run. Refer to SECTION V to check switch and windings.
Motor overload protector has cycled.
Wait two or three minutes for overload protector to
reset. If protector cycles repeatedly, refer to
paragraph 43.
Bind in upper or lower motor bearing.
Remove belts and determine if motor shaft
will spin.
Replace motor if shaft is locked up.
Broken, loose, or incorrect wiring. Refer to appropriate wiring diagram .
Power cord is miswired. Refer to appropriate wiring diagram for correct
wiring .
36793
63