Raytheon Speed Queen AWM190 Service Manual page 66

A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~-.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be •
reconnected to ensure that the washer is properly grounded.
w
003
41. NO AGITATION
POSSIBLE CAUSE
• •
••
Inoperative timer. Timer is designed to pause Test timer and replace if inoperative.
(SOAK) during DELICATE cycle.
Motor will not run. Refer to SECTION V to check switch and windings.
No Delicate cycle agitate. Refer to SECTION V to check low speed switch and
windings.
Inoperative pressure switch. Test switch and replace if inoperative.
Broken, loose, or incorrect wiring. Refer to appropriate wiring diagram.
Loose or broken drive belt. Adjust or replace belt.
Inoperative transmission assembly. Repair or replace transmission assembly.
Sheared motor pulley roll pin. Remove drive motor and replace roll pin and
any other damaged parts.
Motor overload protector has cycled. Wait two or three minutes for overload protector
to reset. If protector cycles repeatedly , refer to
paragraph 43.
Bind in pump. Replace pump.
Loading door is open or door switch is inoperative.
Close door or test switch and replace if inoperative.
•
42. CONSTANT AGITATION
POSSIBLE CAUSE TO CORRECT
Inoperative timer. Test timer and replace if inoperative.
Shorted or incorrect wiring.
Refer to appropriate wiring Diagram.
Inoperative transmission assembly. Repair or replace transmission assembly.
•
64
36793