Raytheon Speed Queen AWM190 Service Manual page 32

A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be •
reconnected to ensure that the washer is properly grounded.
woo
3
IMPORTANT: When installing outer tub cover,
always use a new cover gasket.
NOTE: Clean and remove any foreign material in
gasket groove of outer tub cover and outer tub
flange.
h. Starting at positioning pin located between
two bleach funnel outlet tabs, lay gasket into
gasket groove of tub cover, Figure 38
i. Using your fingers, press gasket down into
gasket groove of tub cover. Avoid pressing
gasket past ends of hold-down tabs.
IMPORTANT: Care must be taken not to twist or
bunch gasket in any one area to avoid leaks after
assembly.
j. Install gasket past ends of hold-down tabs to
bottom of gasket groove using semi-curled
end of tub cover tool Part No. 273P4.
NOTE: Tub cover tool part No. 273P4 is designed
to spread open hold-down tabs to prevent tearing
of gasket during installation.
TUB COVER
GASKET
HOLD-DOWN
TABS
k. With tub cover tilted at approximately a
45 degree angle, insert the positioning pin
into notch on outer tub flange,
Figure 39.
NOTE: The two bleach funnel outlet tabs must be
angled downward toward inside wall of outer tub
for proper dispensing of bleach.
I. Lower cover and push down firmly on top of
hold down tabs next to positioning pin until
tabs snap over edge of outer tub flange.
m. Cross over to opposite side of tub cover and
push down firmly on top of hold down tabs
until tabs snap over edge of outer tub flange.
Continue with this criss-cross pattern, until
tub cover is fu lly seated. Visually check each
tab area again to ensure cover is seated.
n. Check whether or not bleach drain tabs are in
the down position by looking through the
square holes in bleach funnel area of tub
cover. If tabs are not down, a small
screwdriver can be inserted down through
holes in bleach funnel area to straighten tabs.
PRESS GASKET INTO
GROOVE USING YOUR
FINGERS
(continued on page 32)
273P4
TUB COVER
TOOL
HOLD-DOWN
TABS
W208SE3A
Figure 38
30
36793
•
•