Table of Contents
Advertisement
A W A R N I N G - - - - - - - - - - - - - - - - - - - - - - - - - - - - - .
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
•
reconnected to ensure that the washer is properly grounded.
woo3
18. CABINET TOP ASSEMBLY
a.
Remove two
screws
from bottom
edge
of front
panel, Figure
26.
b.
Pull bottom of panel
away from
washer until
hold-down
clips
(located on top
flange
of panel)
disengage from
slots
in cabinet
top,
Figure
26.
c. Remove two
cabinet
top hold-down
screws,
Figure
26.
d. If area or space permits,
tape loading
door
closed
and lift
cabinet
top
to a vertical
position
by hinging
it
on the rear
hold-down
bracket.
NOTE: Cabinet top
is
self-supporting,
however,
a
small chain may be used for additional support,
Figure 27.
IMPORTANT: Before lowering cabinet
top into
position, pivot outer
tub
forward far enough to
prevent damaging
(bending)
the out-of-balance
switch lever.
TO REMOVE CABINET TOP FROM WASHER
a.
Repeat
steps "a", "b" and
"c" above.
b. Remove
six
screws (3 on top and 3 at
lower
front) holding
hood
assembly to control
hood
rear
panel
and cabinet top,
Figure
28.
c. Disconnect
hose
from pressure
switch
and
push hose down through
hole in cabinet
top.
d. Disconnect
wire
harness
at disconnect
blocks.
e. Reinstall
control
hood
assembly.
f. Tape loading
door
closed.
g. Lift front
of cabinet
top
slightly and
pull
forward to disengage from rear hold-down
brackets.
h. Pull top forward far
enough
to permit
disconnecting green ground wires
from
top
left
rear corner of washer
cabinet,
Figure
29.
i. Disconnect wires from mixing valve solenoids
at quick disconnect blocks, Figure
29.
24
NOTE: Refer to appropriate wiring diagram when
rewiring mixing valve solenoids.
j.
Carefully lift
cabinet
top off washer and set
alongside the washer cabinet on protective
padding.
IMPORTANT: DO NOT lay cabinet top flat because
it will damage door switch actuator arm or lever.
When reinstalling cabinet top and before lowering
top into position, pivot outer tub forward far
enough
to
prevent damaging (bending) the out-of-
balance switch lever.
I
I
I
..._0
'
:Jo:----
-- '
e' -
--
--
--"'
&"::.::' W214SE1A
Figure 27
36793
•
•
Advertisement
Table of Contents
