Table of Contents
Advertisement
A
WARNING~~~~~~~~~~~~~~~~~~~~~~~~~~--..
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
•
reconnected to ensure that the washer is properly
grounded.
woo3
IMPORT
ANT:
Use a small pocket mirror to check
entire circumference of seal flange making sure
seal is pressed down against shoulder on hub;
there should be no
gap!
p.
Turn seal tool upside-down and place small
end over output shaft and onto washer,
Figure 20.
q. Push down on tool with a quick motion until
tool bottoms out and top
of
seal is fully
seated,
Figure 20.
274P4
SEAL
-......_·
I
TOOL
~
Figure 19
HUB
16
TO INSTALL NEW DRIVE BELL
a.
Position new drive bell over
trans
mission
shaft.
Rotate drive bell until splines in
drive
bell line up with splines on transmission shaft.
b.
Push drive bell down on transmission shaft.
c. Place new "O" Ring onto new shoulder
screw.
Thread shoulder screw down through
hole
in top of drive bell and into transmission
shaft.
NOT
reuse
old screw or
"O"
ring
.
NOTE: Torque new
shoulder
screw to
approximately 75 inch pounds.
d. Place agitator on top of drive
bell.
Slowly
rotate agitator until fingers on underside
of
agitator line up with large slots on
drive
bell.
e. A sharp blow on top of agitator, with palm of
your hand, will force agitator down onto drive
bell,
allowing fingers on underside of agitator
to lock under bottom edge of drive bell.
NOTE: Do not push agitator onto drive bell any
further than necessary.
WASHER
Figure 20
TOP
OF
SEAL
36793
•
•
Advertisement
Table of Contents
