Table of Contents
Advertisement
Selecting FROM and TO Sources
Proceed as follows to select the FROM and TO sources.
oO
eee
meee
com
0
eee
oO
BS:88:83:68
8BS8:85:88
ves
88:d6:00:08
Selecting FROM and TO sources
1 Press the A/B button.
The button lights. If it is flashing, it stops flashing and lights.
The green indicator in the FROM row of the FROM TO section lights.
2 Press the P1 or P2 button to select the FROM source.
e The button lights. At the same time, the red P1 or P2 indicator in the FROM
row lights.
e The green FROM indicator goes out, and the green TO indicator lights.
A duration must be set when using an auxiliary source (AUX 1, 2, 3).
For more information, see "Using Auxiliary Sources" (page 6-5(E)).
3 Select the TO source by pressing the P1 or P2 button, whichever is not lit.
e The button lights. At the same time, the red P1 or P2 indicator in the TO row
lights.
e The green TO indicator goes out. Both of the green indicators are now out.
A duration must be set when using an auxiliary source (AUX 1, 2, 3).
For more information, see "Using Auxiliary Sources" (page 6-5(E)).
How the FROM and TO indicators change
The green FROM and TO indicators change in the following order each time you
press the FROM TO button. The green FROM and TO indicators are never lit at
the same time.
__
FROM indicator lights ——————————————_
TO indicator lights
FROM and TO indicators go out Bees
ee ae
Except while you are selecting FROM and TO sources, make sure that the green
FROM and TO indicators are not lit. The lighted state means that FROM or TO
sources can be changed, which can lead to errors.
cnapters
{|
|{T TTI
5-4 (E)
Chapter 5 Editing with Two Players — A/B Roll Edits
Advertisement
Table of Contents
