Table of Contents
Advertisement
Select the edit mode
(page 4-3(E))
EE
Execute the edit
If necessary, review the edit
(page 5-6(E))
(page 5-7(E))
(page 4-9(E))
(page 4-11(E))
(page 4-12(E))
(page 4-13(E))
A/B roll editing session
Confirm special effects before execution
Confirm that necessary settings, including effect selection, have been made
correctly on the switcher or mixer side before executing a preview or an edit.
Note on references to Chapter 4
differs from cut editing in the following ways.
e Confirming and adjusting edit points
Before adjusting or confirming player edit points, it is necessary to select the
FROM or TO source by pressing the P1 or P2 button. The button lights to
indicate the selected source.
e Moving an OUT point during a preview
If you wish to move an OUT point backward during a preview, wait until after
the transition. Then, when the player reaches the desired scene, press the
recorder OUT button while holding down the ENTRY button.
e Moving an OUT point during an edit
If you wish to move an OUT point backward during an edit, wait until after the
transition. Then, when the player reaches the desired scene, press the AUTO
EDIT button or press the recorder OUT button while holding down the ENTRY
button.
HN
Chapter
5
Advertisement
Table of Contents
