Sony PVE-500 Operating Instructions Manual page 39

To record new time codes on a recorded tape in insert mode
OoOeees Oeese ooo ce ot a)
98:83:68:68 S@:98:86:88 ees 98:88:86:86
axb
To record new time codes on a recorded tape in insert mode
After setting the time code, do not exit the setup menu.
2 Select setup menu item SEtUP-28 (abbreviation: tc droP) to select drop frame
mode or non-drop frame mode.
Do not exit the setup menu.
3 While still in the setup menu, press the EDIT button together with the PLAY
button in the recorder operation control section.
Recording begins with a time code approximately 20 seconds or 60 seconds
(depending upon the setting of setup menu item SEtUP-29) before the initial
time code selected in step 2.
4 To stop the recording, press the ALL STOP button.
5 After you have finished recording, press the SETUP (ENTRY + EDIT) button
to exit the setup menu.
If the recorder and player tapes have different formats, and you want to record time
code signals on the player tape in insert mode, temporarily connect the player VIR
to the RECORDER connector. In this case, the player VTR must have a time code
insert function.
Chapter 3 Preparations
HIN
Chapter 3
3-17 (E)