Table of Contents
Advertisement
Setting (factory
setting underlined)
EDIT DELAY
SEtUP-11
|Ed dELAy | Auto: Adjusted automatically for the VTR
The recorder edit delay, or number of frames
device type). For devices not
from the time when the editor issues a
registered with this unit, the default
command until the time when the recorder
value is three frames.
begins recording. Correct the command timing
1F/2F/-../15F: Number of frames, in range
as necessary.
1to 15
When editing in modes other than Auto,
experiment and select the correct timing.
You can display the VTR device type. For
more information, see "To display the
VTR device type" (page 3-13(E)).
RECORDER START DELAY
SEtUP-12
jrdELAy
| Auto: The registered value
Whether the recorder start delay shall be the
LEArn: The learned value
value registered for the VTR type, or the value
returned by the learn function.
However, the default value of five frames
is used when
You can confirm whether or not a start delay
¢ the VTR type cannot be determined
value has been learned. See "To display the
with this item set to Auto.
VTR device type" (page 3-13(E)).
e no value has been learned with this
item set to LEArn.
PLAYER 1 START DELAY
SEtUP-13
|P1dELAy | Auto: The registered value
Whether the start delay for player 1 shall be
LEArn: The learned value
the value registered for the VTR type, or the
value returned by the learn function.
However, the default value of five frames
is used when
¢ the VTR type cannot be determined
with this item set to Auto.
¢ no value has been learned with this
item set to LEArn.
PLAYER 2 START DELAY
SEtUP-14
|P2dELAy | Auto: The registered value
Whether the start delay for player 2 shall be
LEArn: The learned value
the value registered for the VTR type, or the
value returned by the learn function.
However, the default value of five frames
mii
Chapter
3
is used when
e the VTR type cannot be determined
with this item set to Auto.
* no value has been learned with this
item set to LEArn.
not synchronize if the source VTR is
in DT playback mode.
Set t
i
VT
i
et to OFF when using a
VTR which does not
OFF: Do not synchronize.
support synchronization.
SEtUP-16 | P1 Sync | On:
Synchronize if recorder
PLAYER 1 SYNCHRONIZATION
sapere
e a e
:
synchronization is set to OFF. lf
Whether to synchronize player 1 or not.
recorder synchronization is set to
On, synchronize when player 1 is
RECORDER
SYNCHRONIZATION
SEtUP-15
|rEC Sync
On:
Synchronize if the source
in cut Ae
:
editing or if the FROM source in
Whether to synchronize the recorder or not.
roll editing is a VTR.
However, do
the TO source, or when player 1 is
in DT playback mode.
OFF: Do not synchronize.
PLAYER 2 SYNCHRONIZATION
SEtUP-17
|P2 Sync
Qn:
Synchronize if recorder
Whether to synchronize player 2 or not.
synchronization is set to OFF. If
recorder synchronization is set to
| Note |
On, synchronize when player 2 is
Set to OFF when using a VTR which does not
support synchronization.
Set to OFF when using a VTR which does not
the TO source, or when player 2 is
support synchronization.
in DT playback mode.
OFF: Do not synchronize.
a) A code identifying the VTR type.
Chapter 3 Preparations
3-11
(E)
Advertisement
Table of Contents
