Sony PVE-500 Operating Instructions Manual page 43

oY} (Yeu fare Migi=m elimi felel=
Select assemble mode or insert mode.
Assemble editing and insert editing
What is assemble editing?
If you begin an assemble edit at a point midway through an already recorded tape,
data will be erased across the entire width of the tape a few seconds after the
recorder's OUT point.. Video and audio signals recorded in this section will be
lost, causing picture break up. If you wish to avoid this, use insert editing instead
of assemble editing.
What is insert editing?
Insert editing is a technique for inserting video, audio (channels 1 and 2), time code
and control signals into a master tape, either together or separately. It assumes that
you have already recorded control or time code signals across the entire length of
the tape. Use insert editing when you want to:
e add music or narration to an edited video program.
e add video to an edited audio program.
e take a tape recorded in assemble mode and replace certain scenes with new ones.
In insert mode, you can insert new scenes without causing picture break up after
the recorder OUT point.
Insert editing
CTL
Video
aaa
A
mrs Mec Ss eS
puta ee Audio 1
ae eat ee ae
[J Audio 2
Scenes rearranged Scenes eae
Video and audio (1 and 2) Video and audio (1 and 2)
combinations cannot be changed. combinations are alterable and
they can be edited separately.
Assemble and insert editing
Chapter 4 Basic Editing — Cut Edits
HIM
Chapter 4
_ 4-3 (E)