Table of Contents
Advertisement
ENOW00066-1
CAUTION
Do not give a shock to an outboard motor
during transportation.
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine's exterior may be dam-
a g e d or wa ter m ay enter th e cylinder
through the exhaust port and cause engine
problems.
ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
1. Handle
ENOM00950-1
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
ENOF01738-0
tank with fresh oil and fuel. If the fuel
tank is only partially filled, air in the tank
may deteriorate the fuel during storage.
1. Before adding fuel stabilizer additive,
drain the carburetor (See page 60).
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in water for 10 min-
utes to make sure any old fuel in the
fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-1
Note
If your motor is used occasionally, it is rec-
ENOF01727-0
ommended to use a high quality fuel stabi-
lizer for the fuel and keep the fuel tank full
to reduce condensation and evaporation.
INSPECTION AND MAINTENANCE
59
1
ENOF01728-0
10
Advertisement
Table of Contents
