Table of Contents
Advertisement
54
INSPECTION AND MAINTENANCE
ENOW00086-1
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread bend both
end of the pin apart to lock propeller in
place.
A worn-out or bent propeller will lower
the outboard motor's performance, and
cause engine trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.
2. Remove the split pin, propeller nut
and washer.
10
3. Remove the propeller and thrust
holder.
4. Apply waterproof grease to the pro-
peller shaft before installing a new
propeller.
5. Install the thrust holder, propeller,
stopper, washer and propeller nut
onto the shaft.
CAUTION
ENOF00084-B
2
1. Propeller
2. Thrust holder
3. Washer
4. Propeller nut
5. Split pin
6. Tighten the propeller nut to specified
torque and align one of grooves to
propeller shaft hole.
Propeller nut torque:
25 N·m (18 ft·lb, 2.5kgf·m)
7. Install a new split pin into the nut hole
and bend both ends of pin apart to
lock propeller in place.
ENOM00087-B
Spark plugs replacement
ENOW00087-1
WARNING
Do not reuse spark plug, if the insulation
is damaged or sparks can leak through
crack, potentially leading to electric
shock, explosion and/or fire.
1
3
4
5
ENOF00084-C
ENOF00084-E
Advertisement
Table of Contents
