Table of Contents
Advertisement
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 360 mL (11.8
fl.oz.).
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
4N·m (3 ft lb, 0.4 kgf m)
ENOW00095-0
CAUTION
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOW00928-1
If gear oil is spilled, wipe off immediately and
dispose according to the local regulations.
ENOF01733-0
ENON00032-1
Note
If the gear oil color appears to be milky
color, contact your dealer.
ENOM00086-A
Propeller replacement
ENOW00084-1
Do not install or remove propeller on the
outboard motor with spark plug caps
attached, shift in forward or reverse,
main switch at other than "OFF", engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnecting battery cable
is recommended (if equipped).
The propeller edge is thin and sharp. Wear
the gloves while installing or removing to
protect your hands.
INSPECTION AND MAINTENANCE
CAUTION
WARNING
53
ENOF01734-0
10
Advertisement
Table of Contents
