Removing And Replacing The Transceiver Board - Motorola A920 Service Manual

Disassembly

Removing and Replacing the Transceiver Board

26
To remove the transceiver board
1. Ensure the phone is turned off.
2. Remove the battery door (see page 16).
3. Remove the battery (see page 17).
4. Remove the USIM (see page 19).
5. Remove the Front Housing (see page 20).
6. Remove the PCH (see page 23).
7. Using the Torx driver and T-6 bit, remove the 2 screws shown in Figure 12A.
Set the screws aside for reuse.
8. If necessary, lift the transceiver board out of the rear housing as shown in
Figure 12B. Pry outward on the sides of the housing to release the board.
TORX DRIVER
SCREW
A
B
DISASSEMBLY
TOOL
Figure 12. Removing the Transceiver Board
October 27, 2003
A920, A925
TRANSCEIVER BOARD
SCREW
TRANSCEIVER BOARD
6881024B40-A