Level 1 and 2 Service Manual
Removing and Replacing the Transceiver Board
G
6881041B25
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
1.
Remove the battery cover, battery, SIM, antenna cover, and rear housing as
described in the procedures
2.
Using the flat end of the disassembly tool, carefully loosen the transceiver
board from the front housing.
TRANSCEIVER BOARD
Figure 11. Removing the Transceiver Board
3.
Lift the transceiver board completely away from the front housing as shown
in Figure 11.
4.
To replace, align the transceiver board with the front housing and gently press
into place.
Ensure the keypad is correctly positioned in the front housing relative to the
transceiver board. Verify operation of the keys after replacing the transceiver board.
5.
Replace the rear housing, antenna cover, SIM, battery and battery cover as
described in the procedures.
October 14, 2002
.
DISASSEMBLY TOOL
FRONT HOUSING
Disassembly
020585-o
25