Motorola A920 Service Manual page 30

Disassembly
24
10. Disconnect the Display Flex connector by gently prying upward with the
disassembly tool.
11. Disconnect the PCH Flex connector by gently prying upward with the
disassembly tool.
FLEX
DISASSEMBLY TOOL
TRANSCEIVER BOARD
Figure 10. Removing and Replacing the PCH Flex Connector
To replace the PCH
1. Attach both the PCH Flex and the Display Flex as shown in Figure 10. Hold
the Display/PCH assembly at a 90-degree angle to the Rear Housing assembly
while attaching the connectors.
2. Place the PCH/Display in the Rear Housing and secure it by:
• snapping the PIFA into place first, then,
• engaging the two snaps on each side of the PCH.
3. Insert the four screws and torque to 2.3-inch lbs.
4. Replace the front housing, USIM, battery, and battery door as described in the
procedures.
October 27, 2003
A920, A925
020823
020823-o
6881024B40-A