Getting Start
Reading Mode
Mode Selection
»
Hand-held Mode: press and keep holding the trigger to read. Complete one reading or
release the trigger to terminate reading status.
»
Sensor Mode: the environmental luminance changing in front of the engine
automatically initiates reading status. Complete one reading to terminate reading and switch
to idle. Both luminance changing and the Trigger can initiate reading when idle.
»
Continuous Mode: one hit the Trigger to start continuous reading, and on hit to
terminate reading.
** Hand-held Mode
【Pro CMD:0302000】
Sensor Mode Timeout
When the engine reading at Sensor Mode, the period of time before automatically switch to idle is Sensor Mode
Timeout. The timeout counts from the latest environmental lamination change. Notice that a reading completed will
terminate reading status. Default timeout = 2000 ms.
Continuous Mode
【Pro CMD:0302020】
Sensor Mode Timeout
【Pro CMD:0313000】
Sensor Mode
【Pro CMD:0302010】
Tools
Code Programming ON
Code Programming OFF
Page 16