To Manually Turn On The Stop/Start System; System Malfunction; Cruise Control Systems; Cruise Control - Jeep Wrangler Owner's Manual

NOTE:
The Stop/Start system will reset itself back to an ON
condition every time the ignition is turned off and back on.
T M T O T
O ANUALLY URN N
S S
TART YSTEM
Push the Stop/Start OFF switch (located on the switch
bank). The light on the switch will turn off.
S M
YSTEM ALFUNCTION
If there is a malfunction in the Stop/Start system, the
system will not shut down the engine. A "SERVICE STOP/
START SYSTEM" message and a yellow Stop/Start telltale
will appear in the instrument cluster display
If the "SERVICE STOP/START SYSTEM" message appears
in the instrument cluster display, have the system
checked by an authorized dealer.

CRUISE CONTROL SYSTEMS

C C
RUISE
S /
HE TOP
When engaged, the Cruise Control takes over accelerator
operations at speeds greater than 20 mph (30 km/h).
The Cruise Control buttons are located on the right side of
the steering wheel.
Ú page 72.
1 — SET (+)/Accel
2 — CANC/Cancel
3 — SET (-)/Decel
4 — On/Off
5 — RES/Resume
ONTROL
Cruise Control Buttons
STARTING AND OPERATING
WARNING!
Cruise Control can be dangerous where the system
cannot maintain a constant speed. Your vehicle could
go too fast for the conditions, and you could lose control
and have an accident. Do not use Cruise Control in
heavy traffic or on roads that are winding, icy,
snow-covered or slippery.
To Activate
Push the on/off button to activate the Cruise Control. The
Cruise Indicator Light in the instrument cluster display will
illuminate. To turn the system off, push the on/off button
a second time. The Cruise Indicator Light will turn off. The
system should be turned off when not in use.
WARNING!
Leaving the Cruise Control system on when not in use is
dangerous. You could accidentally set the system or
cause it to go faster than you want. You could lose
control and have an accident. Always ensure the system
is off when you are not using it.
109