Jeep Wrangler Owner's Manual page 255

254 SERVICING AND MAINTENANCE
LED FRONT SIDE MARKER
See the following steps to replace:
1. Remove the front wheel liner fasteners to access
side maker screw and electrical connector.
2. Remove fastening screw in the back of the front side
maker assembly and disconnect electrical connector.
3. Remove and replace LED front side marker light
assembly.
Refer to an authorized dealer for service.
HALOGEN FRONT FOG LAMP
See the following steps to replace:
1. Reach under the vehicle to access the back of the
front fog lamp.
2. Disconnect the wire harness connector from the front
fog lamp connector receptacle.
3. Firmly grab the bulb by the two latch features and
squeeze them together to unlock the bulb from the
back of the front fog lamp housing.
4. Pull the bulb straight out from the keyed opening in
the housing and then connect the replacement bulb.
NOTE:
Refer to an authorized dealer for service.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the bulb
comes in contact with any oily surface, clean the bulb
with rubbing alcohol.
LED Front Fog Lamp
If your vehicle is equipped with LED fog lamps they are
replaced as an assembly. Please see an authorized dealer
for service.
REAR TAIL, STOP, TURN SIGNAL, AND BACKUP
LAMP
See the following steps to replace:
1. Remove interior trim panel cap to access single
retaining screw for tail lamp assembly.
Taillight Access Trim Cap
2. Remove retaining screw and disconnect electrical
connector, then remove tail lamp assembly from the
vehicle.