Getting To Know Your Vehicle - Jeep Wrangler Owner's Manual

NOTE:
 In case the ignition switch does not change with the
push of a button, the key fob may have a low or fully
depleted battery. A low key fob battery condition may
be indicated by a message in the instrument cluster
display, or by the LED light on the key fob. If the LED key
fob light no longer illuminates from key fob button
pushes, then the key fob battery requires replacement.
 Improper disposal of key fob batteries may be harmful
to the environment. Please see an authorized dealer
for proper battery disposal.
To Lock/Unlock The Doors And Swing Gate
Push and release the unlock button on the key fob once to
unlock the driver's door, or twice to unlock all the doors
and swing gate. To lock all the doors, push the lock button
once.
When the doors are unlocked, the turn signals will flash.
When the doors are locked, the turn signals will flash and
the horn will chirp.
NOTE:
All doors can be programmed to unlock on the first push
of the unlock button through the Uconnect Settings
page 128.
Ú
Replacing The Battery In The Key Fob
The recommended replacement battery is CR2450.
NOTE:
 Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin battery
dimensions.
 Perchlorate material — special handling may apply.
 Do not touch the battery terminals that are on the back
housing or the printed circuit board.
 When a key fob battery is low, a warning will be indi-
cated on the vehicle's instrument cluster, and the key
fob LED will no longer illuminate with a button press.

GETTING TO KNOW YOUR VEHICLE

1. Remove the back cover of the key fob by inserting a
flat-blade screwdriver into the slot on the bottom of
the key fob. Pry until the cover unsnaps being
careful not to damage the seal. Proceed counter-
clockwise to pry the remaining snaps until the
battery cover can be removed.
1-3 – Back Cover Pry Points
17