Starting The Engine - TOHATSU EverRun MX 40D3 Owner's Manual

32
ENGINE OPERATION
4. Squeeze primer bulb until it becomes
stiff to feed fuel to carburetor. Point
the arrow mark upward when priming.
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb with engine
running or when the outboard motor is
tilted up to avoid fuel from overflowing.
ENOM00045-A

2. Starting the engine

7
ENOW00958-1
Do not remove or install the top cowl
after the engine has started.
The exposed rotating engine parts cause
serious injury.
ENOW00959-0
The top cowl must be installed while the
engine running except in an emergency. If
the top cowl is not installed correctly, water
splash can damage the engine.
ENOW00036-1A
When starting the outboard motor in the
test tank, make sure that:
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
1
2
ENOF00862-0
WARNING
CAUTION
CAUTION
2. Run at idling only
3. Remove the propeller
(See page 58)
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-1
CAUTION
Operating outboard motor without cooling
water will lead to overheating and damage on
the outboard motor severely. In case the
cooling water check port is not discharging
water, stop the outboard motor immedi-
ately, check for any object, debris which may
be blocking the cooling water check port. If
you are unable to locate the cause, consult
an authorized dealer immediately.
ENOW00032-A
CAUTION
Do not keep turning starter motor for over 5
seconds, or the battery may be consumed,
potenti ally making the engine star ting
impossible and/or damaging the starter.
If cranking over 5 seconds fails to star t
engine, return main switch to "ON", and
crank engine again after 10 seconds or more.
Do not try to crank after engine has started.
This model is provided with start in gear
protection.
1
ENOF00863-0