TOHATSU EverRun MX 40D3 Owner's Manual page 51

ENOM00083-0
Washing outboard motor
ENOW00081-1
WARNING
Do not start engine without removing pro-
peller, turning propeller out in the open may
lead to personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
ENOW00920-0
CAUTION
When washing the outboard motor, be care-
ful not to spray the water inside of the top
cowl, especially electrical components.
ENON00026-0
Note
It is recommended to check chemical
properties of water on which your out-
board motor is regularly used.
If outboard motor is used in salt water,
brackish water or water with high acidic
level, use fresh water to remove salt,
chemicals or mud from exterior and
cooling water passage after every use or
before storing outboard motor for long
time. Before flushing, remove the propel-
ler and the forward thrust holder.
INSPECTION AND MAINTENANCE
ENOM00085-F
Flushing attachment
1. Tilt down the outboard motor.
2. Remove the water plug from the gear
case, and scre w in the flushing
attachment.
3. Connect a water hose. Turn on the
water and adjust the flow (Be sure to
seal the water inlet and sub water
inlet, located in the gear case with
tape)
4. Put the shift lever in the neutral posi-
tion and start the engine.
Continue flushing the outboard motor
for 3 to 5 minutes at idling.
5. Stop the engine and water supply.
Remove the flushing attachment and
tape. After the flushing, be sure to
reattach the water plug.
1
2
1. Flushing attachment (option)
2. Tape
51
10
ENOF01324-0