Table of Contents
Advertisement
58
INSPECTION AND MAINTENANCE
3. Insert the oil tube nozzle into the
lower oil plug hole and fill with gear oil
by squeezing the oil tube until oil
flows out of the upper plug hole. Make
sure that no bubbles are coming out
of the upper plug hole and there is no
air inside the gear case.
ENON00033-1
Note
Use genuine gear oil or ones recom-
mended (API GL-5: SAE #80 to #90).
Required volume: approx. :500mL(16.9
fl.oz)
4. Install the upper oil plug, and then
10
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
4N·m (3 ft
lb, 0.4 kgf
·
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOF01333-0
m)
·
CAUTION
ENOW00928-1
CAUTION
If gear oil is spilled, wipe off immediately and
dispose according to the local regulations.
ENON00032-1
Note
If the gear oil color appears to be milky
color, contact your dealer.
ENOM00086-1A
Propeller replacement
ENOW00084-1
WARNING
Do not install or remove propeller on the
outboard motor with spark plug caps
attached, shift in forward or reverse,
main switch at other than "OFF", engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnecting battery cable
is recommended (if equiped).
The propeller edge is thin and sharp. Wear
the gloves while installing or removing to
protect your hands.
ENOF01331-0
Advertisement
Table of Contents
