Table of Contents
Advertisement
Installation
Cable Management
Following the completion of connections to the FE-165 and all the installed equipment, the associated cabling must be dressed into position and
secured for safety. This is achieved by making use of the cable clamps and management brackets provided on the FE-165 and the robotic head.
Cabling can be neatly secured, providing strain relief for the connectors and reducing the risk of cables becoming trapped or damaged.
Robotic Head to Mounting Plate*
If the optional cable management
bracket (Light only) has been fitted to the
head mounting plate, attach all cabling
as shown using cable ties. Provide a
sufficient loop of
slack
in the cables so
the robotic head can freely rotate
through 360 degrees.
Column Top to FE-165 Body
Loosen the main body cable clamp knob
sufficiently to feed the cabling from the
head into the channels in the clamp
block. To permit unrestricted and safe
movement of the elevation column
through it's full stroke range, provide a
minimum slack loop in the cabling
between the head mounting plate and
the main body clamp of
890 mm (35 in.)
Do not over-tighten the cable clamp knob
when securing the cabling.
FE-165 Body to Leg Clamp
Route the cabling through the leg clamp
using the same method shown in step 2.
Also route any additional cabling from the
FE-55 connectors through the leg clamp.
Cable Dressing
Use additional cable ties to keep the
cables together on long runs.
22
*On the Elite version, cables can
be secured to the steering wheel
arms in the absence of the cable
management bracket
.
360°
loop
890 mm
(35 In.)
loop
Advertisement
Table of Contents
