Vinten FE-165 Light User Manual page 6

Safety
Water, Moisture and Dust
WARNING! Protect the product from water, moisture and
dust. The presence of electricity near water can be
dangerous.
Ventilation
CAUTION! Slots and openings are intended for ventilation
purposes to ensure reliable operation of the product and
protect it from overheating. Do not block or cover any slots
and openings.
Operating Environment
CAUTION! The product should not be used outside the
operating temperature limits. Refer to the product technical
specifications for the operating limits for the product.
Cleaning
WARNING! Risk of electric shock. Always disconnect and
isolate the product from the power supply before cleaning.
CAUTION! Do not use abrasives or wire brushes to clean the
product. Clean with a soft dry cloth.
Maintenance
WARNING! This product is fitted with a pressurised gas
vessel. The removal of any covers, and the undertaking of
any servicing or repair work must only be carried out by
approved and qualified service engineers.
4
WARNING! The fitting of non-approved parts or accessories,
or the carrying out of non-approved alterations or servicing
can be dangerous and could affect the safety of the product. It
may also invalidate the terms and conditions of the product
warranty.
Safety when Working with Robotic Equipment
In normal operation remote-controlled equipment can move suddenly
and without warning. Since audible warnings are not suitable for use
within the studio environment, it is recommended that only trained
personnel be allowed to work in the active areas where remote-
controlled robotic equipment is located.
The safe operating zone is a minimum of 1 m (3 ft).
Safety Notes for Operators
Operators must familiarise themselves with the working footprint of the
robotic equipment, including all installed payload items (lens, zoom and
focus controls, viewfinder, prompter, etc.) to prevent inadvertent
collisions or injury to personnel.
If personnel are too close to robotic equipment that is about to move,
the operator should prevent the motion from starting or stop the motion
if it has started.
We strongly recommend that the operator verifies visually that the
active area is clear of hazards and personnel, both before and during
remote operation.