Module Programming - Directed DIRECTECHS DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Ensure vehicle is in a safe location and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2. Connect the 12-pin.
2
3. Connect the 10-pin.
4. Connect the 4-pin D2D cable (if being used).
When the LED turns ON solid red, proceed with the next step.
3
Press Unlock on the OEM remote.
Press the Push-to-Start (PTS) button one time (1x) to turn the ignition ON.
4
The LED flashes orange while the module is being programmed.
When the configuration is completed, the LED will turn ON solid green for 3 seconds, then
5
turn OFF.
6
Press the PTS one time (1x) to turn the ignition OFF.
You have successfully completed the module programming sequence.
11
403.VW18 2.05 2024 Volkswagen Jetta GLI (Smart Key)
©2023 Directed. All rights reserved.