1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. Directechs DB3
  6. Installation manual

Directed DIRECTECHS DB3 Installation Manual

Smart key for 2013 toyota highlander
Hide thumbs Also See for DIRECTECHS DB3:
Table of Contents

Advertisement

Quick Links

Download this manual
Functions compatible with the 2013 Toyota Highlander (Smart Key)
*Telematics features: The telematics features listed below (with an asterisk) ONLY apply when using SmartStart Pro.
* Odometer
Arm Factory Security
Auto Headlamp Shutoff
Brake Status (foot brake)
Control of aftermarket alarm with OEM remote
Disarm Factory Security
Door Lock Control
Door Locks Status
Door Unlock
Driver Priority Unlock
E-Brake Status
2013 Toyota Highlander (Smart Key)
Entry Monitoring ALL Door Pins
Entry Monitoring Hood Pin
Entry Monitoring Trunk/Hatch Pin
Factory Alarm Trigger Monitoring
Fuel level/EV battery level
Hatch Glass Release
Ignition Status
Immobilizer Bypass-Data No Key Req'd
Remote Start Ready
SmartStart
Tach / RPM Output
403.TL1
v5.07.106

Advertisement

Table of Contents
loading

Related Manuals for Directed DIRECTECHS DB3

Summary of Contents for Directed DIRECTECHS DB3

  • Page 1 403.TL1 v5.07.106 2013 Toyota Highlander (Smart Key) Functions compatible with the 2013 Toyota Highlander (Smart Key) *Telematics features: The telematics features listed below (with an asterisk) ONLY apply when using SmartStart Pro. * Odometer Entry Monitoring ALL Door Pins Arm Factory Security Entry Monitoring Hood Pin Auto Headlamp Shutoff Entry Monitoring Trunk/Hatch Pin...

  • Page 2: Table Of Contents

    Contents Introduction Pre-installation and application warnings Key type OEM remote starter detection Installation Wiring diagram with T-Harness (TLTH1 & THTOD1) Wiring diagram Locating components in the vehicle Vehicle connections Module programming Push-to-Start (PTS) vehicles with CAN Connecting the module LED diagnostics and troubleshooting Soft reset Hard reset Feature programming...

  • Page 3: Introduction

    Press the remote control’s lock button twice within 2 seconds, then press and hold the lock button for 3 seconds. Press & Hold & for 3 seconds 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.
  • Page 4 STARTER If the vehicle is equipped with an add-on Lexus/Toyota OEM remote starter The factory remote starter must be permanently disconnected before programming the Directed interface as both modules cannot coexist. See "Locating the OEM Remote Starter" below. Locating the OEM Remote Starter Vehicle OEM Remote Starter &...

  • Page 5: Wiring Diagram

    (AC) Tach Output: Violet/White: 5 (+) Ignition Status Output: Gray/Black:7 Refer to the Vehicle wiring reference chart for more information on vehicle-specific wiring connections. XKD2D65 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.
  • Page 6 (-) Push-To-Start: Pink, pin 7 Autolight: (-) Parking Lights: Lt. Blue, pin 18 Green, pin 19 ENGINE START 5 4 3 STOP 10 9 PTS Switch (black conn. behind PTS button) XKD2D65 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 7: Locating Components In The Vehicle

    Locating components in the vehicle 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 8: Vehicle Connections

    No Connection H2/12 Blue/Red (-) W2W Only - Hood Output Remote Starter Input 10-pin black connector (H3) Module Connects To Conn./Pin Color Description Wire Location (+/-) Wire Color 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.
  • Page 9 20 pin plug, pin 18 lt. blue Trunk/Hatch Release driver kick, gray 12 pin plug, pin 1; black 18 pin plug, pin 13 yellow (liftgate); beige (glass) (rear handle switch) 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 10: Module Programming

    Refer to "LED Diagnostics & Troubleshooting" for more information. The module is now programmed. Press the PTS button once more to turn the ignition OFF. You have successfully completed the module programming sequence. 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 11: Connecting The Module

    (12-pin) (D2D) (10-pin) (14-pin) W2W installation If required: Connect the 10-pin and 12-pin harnesses to the module, then connect the 14-pin harness to the module. (12-pin) (10-pin) (14-pin) 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 12: Led Diagnostics And Troubleshooting

    External Module Synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.
  • Page 13 The smart key was not detected, which prevents the system from shutting down the vehicle. Flashes red x 3 Speed was detected. The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 14: Soft Reset

    Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the LED starts & to flash orange and red. Solid Flashes Release the programming button. The LED turns ON solid red. & Solid Release 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 15: Feature Programming

    To exit feature programming, press and hold the programming button for 3 seconds or ensure there is no activity on the interface for 30 seconds. The LED will turn ON orange for 2 seconds to confirm the end of the programming sequence. 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 16: Feature And Option List

    Smart OEM Alarm Control will behave like a standard Safelock feature on a remote starter. It will unlock at the 2. Safelock beginning of the sequence, and relock after start and shutdown. 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.
  • Page 17 This Warranty gives you specific legal rights and you may also have other rights which vary from state to state. VOXX DEI LLC, 2351 J. Lawson Blvd., Orlando, Florida 32824 403.TL1 5.07.106 2013 Toyota Highlander (Smart Key) ©2024 Directed. All rights reserved.

  • Page 18: Quick Reference Guide

    Refer to your authorized installation center for more • Aftermarket remote. specific information. • Directed SmartStart application via your smartphone. Button(s) Actions If applicable, you can also start the engine remotely by pressing the Lock button 3 Press & hold for 1 second to lock.

Table of Contents