Directed DIRECTECHS DB3 Installation Manual page 7

Method 3: Key wrap for Push-to-Start (PTS) using OEM immobilizer ring
Note: OEM immobilizer receiver is located
on the underside of the steering column,
where the ignition switch would normally be.
- Make 4-6 loops and place the around the front of the plastic body of the vehicle's coded key as shown above.
- Connect with OEM Immobilier Ring as shown in the above diagram.
- When possible, use valet key for key wrap. if blade key is used, battery must be removed.
7
403.VW18 2.05 2024 Volkswagen Jetta GLI (Smart Key)
©2023 Directed. All rights reserved.
OEM
Immobilizer
Receiver
NC Relay 2: Orange/Red: 10
Common Relay 2: Yellow/Red: 11
NO Relay 2: Brown/Red: 12
4-6 loops
Remove battery from
OEM Remote Control
Immobilizer ECU