Important Safety Information - Projecta IS1400 Manual

Intelli-start 12v lithium jump starter and portable power bank
Table of Contents

Advertisement

IMPORTANT SAFETY INFORMATION

Please read this manual thoroughly before use and store in a safe place for
future reference.
WARNINGS
This unit has been designed for vehicles with 12V DC electrical systems only.
This appliance contains batteries that are non-replaceable – during charging, the
battery must be placed in a well-ventilated area (for chargers for batteries that
release gases into the atmosphere during normal charging).
Risk of explosive gas. Working in the vicinity of car batteries can be dangerous. Batteries
release explosive gases during normal operation, charging and jump starting. Before using
this jump starter, read and follow the instructions carefully. Follow all manufacturer's
instructions and warnings of the vehicle's battery and other equipment being used.
Jump start 12V DC automotive lead acid batteries only. Do not use to jump start dry
cell batteries commonly found in household appliances. These batteries may burst
and seriously cause injury and/or property damage.
Do not smoke, use matches, use a cigarette lighter, or allow a spark or flame near
the battery.
Do not allow metal to come in contact with the battery posts. It may spark or short-
circuit the battery and cause an explosion/fire.
Remove rings, bracelets, necklaces, and watches when working at the vehicle and/or
jump starting a vehicle.
The jump starter contains a sealed non-spillable Lithium Iron Phosphate battery
(LiFePO
4
Ensure correct polarity when connecting to vehicle.
The jump starter is not designed to be left outside for extended periods of time or
submerged in water.
Do not store the jump starter in temperatures above 45˚C or below -10˚C as this can
affect the health of the internal battery.
Always wear eye protection when operating the jump starter.
Although the jump starter has been designed to protect the battery, do not drop the jump
starter or attempt to pierce it in any way. This can result in an explosion and/or fire.
If the jump starter is physically damaged in any way, it should not be used.
Not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction - children being supervised not to play with the appliance - only
to be used with the power supply unit provided and it must only be supplied at SELV.
Do not try and charge the unit via its own USB output as this will damage the jump
starter and the USB output.
Do not allow positive/red and negative/black clamp touching each other when in
override mode and 12V DC mode.
When in manual override, pay careful attention not to reverse-connect clamp or
short-circuit.
Do not charge jump starter from laptop/computer USB ports.
Do not leave clamps connected to external battery indefinitely for it will continuously
drain the jump starter battery.
2
). This must be disposed of properly.

Advertisement

Table of Contents
loading

Table of Contents